Experimental analysis of strengthening effect of corroded reinforced concrete beams strengthened with bolted steel plates
Peng Jianxin, Li Ju, Tang Huang and Zhang Jianren
DOI:10.11835/j.issn.1674-4764.2015.01.015
Received July 29, 2014,Revised , Accepted , Available online July 01, 2015
Volume ,2015,Pages 88-95
- Abstract
In order to study the mechanical behavior of corroded reinforced concrete beams strengthened with bolted steel plates, this paper designed 12 reinforced concrete beams. These beams were corroded by using accelerated electrochemical corrosion method with a designed corrosion ratio of 10%. The pre-compression experiments were performed for all RC beams before strengthening and the maximum crack width was controlled as 0.2 mm. According to the thickness of concrete cover, the beams were divided into 3 groups. Each group was composed of one comparative beam and three tested beams strengthened by steel plates bolted with study according to the thickness of steel plates which were 3 mm, 4 mm and 5 mm, respectively. It was shown that the strain distributions along the height of the strengthened beams at middle-span were in good agreement with the plain section assumption basically. The serviceability performances of corroded RC beams were significantly improved and these ultimate bearing capacities increased obviously. The steel plate bolted with stud effectively reduced the crack width and the extension height of reinforced concrete beams. It was indicated that an increase of steel plates with 35 mm resulted in a decrease of deflection by 13%51% when beams had the same thickness of concrete cover and corrosion ratio. Influence of the thickness of concrete cover on the ultimate bearing capacity was not obvious.